The fungus on the walls appears not only in houses located in a marshy area. It appears regardless of climate, and despite the level of groundwater. The main reason for its appearance is the increased humidity of the soil and air under the floor. And getting rid of him is not easy. It is much easier to suspend the problem that has appeared. Mold also appears with the fungus from dampness. Then dampness begins to penetrate directly into the walls. And the only appearance of the fungus shows that he infected not only the walls, but also the entire soil under the house. Then, after deep wall treatment, it is also necessary to process the entire soil under the house. Use mainly antiseptic compounds. The soil must be completely removed from the underground. And try to ensure that the walls are always dry. And in order to prevent the occurrence of the fungus, it is necessary to make a special drainage ditch. But this method is good if the water in the soil is too high, and can even reach the walls. The ditch is made using geotextile films. But the gravel is also necessary. The drain must be displayed into the general channel. If this is not possible in the area, they dig a special well. The second thing can be done is to provide excellent ventilation. Wet air is an excellent environment for the propagation of various fungi and bacteria. And for good ventilation, when laying the foundation, small holes are left, which are called the poor. But this is not enough. In addition, they are closed in winter. And this already violates the entire ventilation system. It is best to make a special ventilation pipe that will leave the basement out. In this case, ventilation will be much more intense. And the air will be dry.
If there is ventilation under the floor, in winter it is simply necessary to prevent air access to living rooms. Especially for this you can insulate the floor. Simple to lay in the aisles between the beams thermal insulation material. The thickness of such a layer should be approximately a hundred millimeters. A film, which should be a steam -permeable one, fall on it on top of it. It is needed so that steam from the room does not enter the floor. Otherwise, thermal insulation will moisturize, and with it the foundation. If there is no blow under the floor, moisture will certainly begin to accumulate. This will become the main reason for the appearance of mold and fungus. Therefore, ventilation should be in any case. In the absence of purges in the foundation, the problem is solved by the way of withdrawing the pipe to the street. Also, with low ventilation, it is necessary to insulate the walls from the inside. The problem with the fungus also occurs when the walls of the house are piled up with various materials, firewood and boards. Many make from this pile of rain protection. The result of one- ventilation disappears, and the walls gradually rot. The issue is solved by a simple discovery of walls, that is, it is necessary to remove everything from the walls. This will help prevent the appearance of the fungus. And the walls will be better preserved. And with them the house.