A small book shelf in a rural style will be a decoration of any house. And to make its design even easier, three rear jumpers can be replaced with a wall of plywood 6 mm thick. If desired, the size and number of shelves increase. Of the materials for the book shelf, pine, cherry or oak is best suited. It is necessary to take pine boards (with knots) with a cross section of 25×300 mm, but not crumpled and without cracks. True, a shelf from solid wood will look more elegant. Rice. 1. Details of the book shelf. List of details and materials: a) side wall (solid wood board) – 2 pcs. – 20x225x800 c) upper shelf (solid wood board) – 1 pc. – 20x200x725 c) Lower regiment (solid wood board) – 2 pcs. – 20x225x725 D) The rear jumper (solid wood board) – 1 pcs. – 12x87x712 In addition, you need: 50 mm screws for dry plaster; 60-mm finishing nails. The manufacture of a small book shelf begins with the cutting of two side walls along the length and width. Having put the walls with the front side on the workbench, they are pressed to each other and along the square, the grooves for shelves for 20 mm wide are marked in such a way that the upper planes are at a height of 95, 435 and 715 mm from the lower ends of the side walls. Choose grooves with a depth of 6 mm. At a distance of 25 mm from the front ribs of the side wall, a line ending at a distance of 287 mm from its upper end is drawn, and the upper corner and angle above the middle shelf are rounded or in a round object. Rounding over the middle shelf should go on the outer edge of the side wall 325 mm below the upper end of the wall. Then, according to this marking, a narrow hacksaw or jigsaw cut out the upper figure of the side walls. Rice. 2. Side wall template. The template is marked and cut out a figure sample on the lower ends of the side walls. On a circular saw or hacksaw, shelves in and with. Check the rectangularity of the angles. To dock the shelves with the side walls, lubricated with glue grooves for shelves and the ends of the shelves themselves, collect the shelf and tighten it with rack clamps. You can increase the strength of the fastening by scoring through the side walls into the shelves of 60 mm finishing nails. If the regiment is tightened with more than six clamps that provide a strong adhesive compound, the nails are not needed. Remove all excess glue and, while the glue grasps, check the shelf for rectangle. Gently cut three rear jumpers – they must definitely enter between the side walls, without bursting. Then lubricate the lower ribs and ends of the jumpers with glue and clamp them in place so that the rear planes of the jumpers are flickering with the rear ribs of the shelves and the side walls. Excess glue is removed with a damp cloth. 1-2 of the auxiliary openings are drilled on the back of the shelves, they are coded and the jumpers are additionally attached with 50 mm screws for dry plaster. In addition, jumpers can be fixed with 60 mm finishing nails, scoring them through the side walls into the ends of the jumpers. The nails sink and put the hats. The entire book shelf is cleaned with a small skin and covered with several thin layers of varnish or olifa.
8