Recently, during the construction of wooden houses from a log house or timber, plastic windows are used, when installing which it is necessary to observe a special technology, otherwise all the works will be in vain.
Lack of wooden houses-structure mobility The first 5-6 years after housing construction. These are due to the features of wooden products, one of which is a decrease in volumes and subsidence of the house under the influence of moisture. Therefore, it is worth considering the specifics of this material when installing plastic windows. By the way, you can buy PVC windows in bulk and retail even on the Internet.
So that the installation of windows does not become a painful test for you, it is advisable to save the window from the wings. To do this, remove the fixed pins from the loops. Thus, you will facilitate yourself as a rise in the structure during installation, and the installation process itself, since it will be much easier.
The window is installed on chips placed on the lower part of the window opening, then it must be adjusted horizontally using the building level. Below it is better to leave a small gap (2 cm) for further blowing with mounting foam. So that the sash correctly perform its functions, the vertical level should be adjusted.
After all the preparatory processes, the window is attached to the stress using self -tapping screws. This should be done very carefully, avoiding fasteners from getting into the crest of the log, where a burden can be located. It is better to screw a little self -cut a little obliquely than to violate the integrity of the yarrow.
The next step will be the fastening of previously removed window wraps. This must be done before filling the slots with mounting foam, otherwise, deformation of the frame is possible, which will affect the further operation of the window.
If the technology for installing plastic windows in a wooden house was fully observed, then a gap of 5-10 cm will be visible to shrink the log house in the upper jest. This is necessary so that after the final drying of the log house, the upper logs do not exert pressure on the windows.
At the end, you need to check the window for the correctness of the work performed. Without filling the holes with foam, open the window and make sure that the sash do not try to move spontaneously. If everything is in order, then you can blow the frame with mounting foam.
The manufacturer of windows in the Moscow region supplies quality products, so it’s a sin not to take this opportunity.