Home The buildings Aerated concrete YTONG

Aerated concrete YTONG

by 360roomsnews

YTONG aerated concrete – building material made from environmentally friendly raw materials. The material is subjected to steam under pressure, to give the required physical and mechanical characteristics.

1. Environmental friendliness

It is environmentally friendly: the environmental friendliness coefficient = 2 (below only in wood – 1).

2. Economy

The material has an unlimited service life: not older, does not rot, does not burn;

The weight of the enclosing aerated concrete structure is on average 40% lower than the weight of structures made of heavy concrete and brick, which reduces the load on the foundation, therefore, its cost;

reduction of labor costs by 5-6 times;

reduction in the cost of 1m2 masonry by 2-3 times compared to other masonry materials;

reduction in the thickness of the finishing layer from 10mm to 6-7mm, due to the minimum thickness of the seams and the flat surface of the material;

large size and light weight of blocks allow you to increase construction speed to 10 times compared to other building materials;

The annual saving of heating energy is about 30% compared to the house from ceramic brick.

3. The best fire protection

According to GOST 30244-94, cellular concrete belongs to the NG class (non-combustible material). A partition from cellular concrete 75 cm with a straight pressure of fire for more than 2 hours without destroying the structure.

4. Simplicity of processing

The material is easily sawn and cut, which allows you to make structures of various configurations and even more simplifies construction.

5. Good sound insulation

YTONG designs satisfy the regulatory requirements for sound insulation according to SNiP 23-03-2003 “Noise Protection”.

6. Excellent thermal insulation

According to SNiP 23-02-2003, cellular concrete is the only wall material that can be used in construction without the use of additional insulation (min wall thickness 37, 8 cm).

7. High accuracy of size

Allows masonry not on the solution, but on a special mounting gap.

the thickness of the seam is not more than 3 mm;

reduction of “cold bridges” by increasing the uniformity of masonry;

reduction in the load on the foundation;

Reducing the cost of finishing.

8. High strength and durability

Mr. Aziton Ytong has an unlimited service life.

9. Massive homogeneous full block

The homogeneous structure of the material is through and through. Thermal conductivity in any direction is equally low!

10. Balanced heat -accumulating properties

Cellular concrete “breathes”, adjusting humidity in the room and creating a favorable microclimate close to the microclimate in a wooden house: in winter it is warm and comfortable, in the heat – cool.

You may also like

© 360Rooms – 360-rooms.com, 2017-2024. All Right Reserved.