Profiled flooring are sheets made of galvanized steel. Fences from this material always look modern and accurately. In addition, they do not need special care.
Before the construction of the fence, it is necessary to calculate the amount of expenditure material. To do this, take into account the position of the fence; place for future gates and gates; coordinates for laying support pillars. The gap between the racks should not be more than 3 m, since the stability of the structure will depend on it. To carry out the correct calculation of the number of sheets of corrugated board, not only the size of the material itself should be taken into account, but also the parameters of the fence under construction.
Usually, metal pipes are used as supporting pillars to build a fence from corrugated board, which can be with a square or round section. So that rain or melt water does not get into the pipe, its upper end is brewed. Pillars are buried in a hole with a deepening of more than 1 m and a width of about 1, 5 m. The funnel is made in proportion to the size of the fence. If the fence is high, then the racks are buried in the ground more deeply.
Metal pillars are installed in a pit, pre -filled with gravel, and poured with a solution of concrete. The racks are located in an upright position and left alone for up to 72 hours. This is required to fully set concrete.
After hardening the concrete solution, a steel transverse profile is installed for further fixing the corrugated board to it. The number of lag is also determined by the height of the fence from the corrugated board. If the fence is up to 2 m in size, then two lags will be required. With a higher fence – 3 lags. After the lags are fixed, they should be treated with a layer of primer. This is done to protect metal from rust.
Installation of profiled sheets on lags with self -tapping screws is the final stage in the construction of the fence. The corrugated board fits with each other. The sheets are located so tightly that there are no gaps between them.
When working with such material, you need to strictly follow safety precautions. After all, the sheets of the corrugated board are quite sharp and they can be easily cut, so it is worth putting on special gloves while working.
The fence from the corrugated board will serve to guard the peace of mind and solitude of the owners of the site or at home for several decades!