Remember that in order to perform different construction and installation work you will need a hole for corrugated board.
There are currently several types of them. They can easily perform different both oval and round holes. You can purchase a hole for corrugated board without problems at a construction store, as well as through the online store. A hand -hole is a perforator, ticks that you use during installation for quick punching of different holes in such building material as corrugated board and then install the mounting system.
The main technical characteristics are the following: – the minimum thickness of the corrugated sheet should be 0. 63 mm; – the largest width of the trapezoid of the profile sheet can vary from 40 to 100 mm; – the working depth of the perforation itself can easily be regulated, starting from 12 to 80 mm; – The finished diameter of the holes is 10. 5 mm;
This hole punch is a special mechanical device that is designed to break holes in corrugated board. If you look at its design, you will see two special knives (this is a special cutting edge for an even cut), which smoothly lower to the corrugated board under certain pressure when you squeeze it. These knives are always installed on the handle to which you work this kind of lever. From below the handle is located a spring, it serves in order to return this device to the usual position after the hole is made. Now there are already some holes that allow you to make a figure hole. For example, in Europe, all construction work uses holes. This is not surprising, because they are really very easier to work. With a hole punch for corrugated board, set your fence of any complexity quickly enough.